Because the rotating compensator has high compensating ability, and the compensating ability will be enhanced with the increase of pipe bracket displacement, the roller bracket or sliding bracket can be used to arrange it in long-distance and moving overhead pipelines, thus reducing friction resistance and achieving the effect of reasonable control of the driving force of the bracket. Compensator manufacturer

In the process of applying the rotary compensator, the length of each pipe bracket can be calculated according to the specific direction of expansion and the expansion amount, and a certain safety margin can be added on the basis of the calculated length. The purpose is to avoid the problem that the pipe bracket of the rotary compensator can not be fixed on the bracket during operation and then fall off. In the calculation of pipe bracket length, the influence of ambient temperature and installation temperature on pipe displacement must be considered to ensure the stable operation of rotary compensator.

After the application of rotary compensator in heat network engineering, the pipe section near the compensator may produce a certain lateral displacement force. Therefore, in the design stage of rotary compensator, the corresponding sliding and guiding bracket structure must be set up according to the specifications and requirements. Special attention should be paid to the fact that the rotating compensator can compensate the elbow section to a certain extent. Therefore, the guide bracket should not be used on both sides of the elbow (sliding bracket is recommended as the preferred option in the area where the elbow exists). The purpose is to avoid the influence of the lateral displacement on the relationship between the guide plate and the bracket under the influence of the elbow so as to eliminate the stress of the civil bracket. Later, the phenomenon of backward inclination occurs.